-
湖南Single layer tile press series
-
湖南Double layer tile press series
-
湖南Three layer tile press series
-
湖南Floor bearing plate equipment
-
湖南Glazed tile equipment series
-
湖南Jiaochi equipment series
-
湖南C/z/u-shaped steel forming mac
-
湖南Carriage plate forming machine
-
湖南Anti skid embossing equipment
-
湖南Aluminum magnesium manganese 4
-
湖南Ridge tile forming machine ser
-
湖南Light steel keel machine serie
-
湖南Shearing machine bending machi
-
湖南Rock wool foam integrated sand
-
湖南Rolling shutter door equipment
-
湖南Discharge rack series of hydra
-
湖南Export equipment series
-
湖南Kaiping machine series
-
湖南pipe benders
-
湖南Customize cold bending equipme
![湖南820 angle tile press](/uploads/220607/1_151919A0.jpg)
湖南820 angle tile press
![](/enimage/dianhua.png)
820 angle galloping tile press adopts high-quality automatic control software to realize production information management. The automatic control system of the whole unit adopts a highly integrated network, which makes the performance of the automatic system good. It also has the advantages of operation, maintenance, mechanical debugging, easy die replacement and so on
the problems that should be paid attention to in the production of 820 angle slip pressing machine are:
1. Please start the motor to idle first and observe whether it is normal
2. Place the machine at the intersection of the two plates, adjust the height of the feet on both sides, and pay attention to whether the roller is in the position to be pressed
3. Under normal circumstances, the bending width of the pressing plate is between 11-15mm, otherwise the machine is easy to fall off
4. The intersection of the two plates can be closely fastened together and cannot be disengaged, otherwise the machine is easy to disengage
5. Start the machine, and the user follows the machine. If the front two plates are disengaged, stop the machine and flatten the plates before starting the machine
6. Because this machine is formed at one time, the resistance in the pressing process is large. In order to determine the service life of the motor, please shut down for 5 minutes every 30 minutes
7. Be careful not to damage the roller during use and handling. It is forbidden to strike the roller with a blunt instrument
8. When not in use for a long time, all parts shall be lubricated with engine oil and wrapped to prevent rain leakage
820 main technical parameters of angle galloping tile press:
overall dimension of equipment installation: 1050m × 1400m × 13500m
total weight of equipment: about 9000kg
host power: 5.5kW
hydraulic shear power: 3kw
hydraulic station pressure: 10-12mpa
scale: 25m pitch: 205m
electric control system: the whole machine is controlled by industrial computer PLC
working speed: 8000m/min
roller material of tile press: 45 # hard chromium plating on steel surface
coverage width (m) 820
expanded width (m) 1000
plate thickness (m) 0.4-1.0
section inertia (cm4/m) 410