-
湖南Single layer tile press series
-
湖南Double layer tile press series
-
湖南Three layer tile press series
-
湖南Floor bearing plate equipment
-
湖南Glazed tile equipment series
-
湖南Jiaochi equipment series
-
湖南C/z/u-shaped steel forming mac
-
湖南Carriage plate forming machine
-
湖南Anti skid embossing equipment
-
湖南Aluminum magnesium manganese 4
-
湖南Ridge tile forming machine ser
-
湖南Light steel keel machine serie
-
湖南Shearing machine bending machi
-
湖南Rock wool foam integrated sand
-
湖南Rolling shutter door equipment
-
湖南Discharge rack series of hydra
-
湖南Export equipment series
-
湖南Kaiping machine series
-
湖南pipe benders
-
湖南Customize cold bending equipme
![湖南Light steel shutter equipment](/uploads/220607/1_1135293C.jpg)
湖南Light steel shutter equipment
![](/enimage/dianhua.png)
The shutter forming machine is mainly composed of forming host, PLC computer control system, hydraulic pump station system and full-automatic post shearing system. Shutter molding machine products are mainly used in building facilities, advertising and construction industries. It is a kind of equipment with less investment, fast actual effect, convenient materials and wide application. The products produced by this equipment have the characteristics of beautiful appearance and can be spliced and installed in a variety of colors
the forming speed of light steel shutter equipment is 0.5-250m/min, and the commonly used speed range is 25-30m / min. The main factors that affect the forming speed of Jiajia include: the composition of the strip steel, the yield strength and hardness of the strip steel, the thickness of the strip steel, the difficulty of the forming operation, the length cutting of the formed profile, the number of forming frames, the auxiliary processing required, and the application of lubricant (coolant)
the lower limit forming speed (0.5m/min) is required to process Qin alloy into complex profiles. Correspondingly, the upper limit forming speed can be used for forming under the ideal forming condition - F. for example, aluminum and Annealed Low Carbon Steel with a thickness of less than 0.9mm and a long fixed length (about 25m) can reach 245m/min when the forming is relatively mild. In order to achieve the highest forming speed, even if the total deformation is small, more forming passes are often used to reduce the deformation of passes on each forming machine. When high-speed forming is adopted, it is usually impossible to carry out auxiliary processing such as punching, stamping, welding, etc., and lubrication is required one by one
when flying shears or flying saws are used to determine the length, they often cannot reach the large speed allowed by molding. The sizing of most roll bending products is through sliding shear (or sawing) machine base. The higher the forming speed is, the longer the sliding base needs to move to determine the accurate sizing Therefore, the actual allowable large forming speed often depends on the size of the shear cycle
parameters of light steel shutter equipment:
forming cycle: 1 second
transmission mode: gear transmission / chain transmission
working air pressure: 4000 MPa
excitation frequency: 300 times / minute
type: mechanical equipment
overall dimension: 3000*600*1200 cm
purpose: zinc steel profile manufacturer
vibration frequency: continuous Hz
machine weight: 0.66 T
diameter: 2.0m
total power: 3kw
forming pressure: 1 Ton